You need to place the moisture trap the farther you can from the output of the compressor. The last thing that you want is to get water and oil mixed up with the paint while airbrushing. You need a moisture trap to get rid of that. Another thing to consider is the water that is always present within the air inside the compressor.In order to get there, you need a good reducer (aka pressure regulator) to get the psi you need For airbrushing, you need 10 to 20 psi. 10 psi is the best for fine details (at risk of clogging), while 20 psi is better suited for experienced users. Air compressors usually have pressure up to 100 to 150 psi or more.Here are the things you need to do to be successful: You can speed up the process by using a heat gun or a hairdryer, though.Ĭan You Use a Regular Air Compressor for Airbrushing? It might take longer if you applied a thick layer of pain. After applying the paint, let it dry for at least 24 hours.Remember that the closest you get to the object, the thinner the lines will be. Use the airbrush on some scrap to get yourself started. If you are a complete beginner, I think it might be a good idea to get some practice first. In some airbrushes, you might need to pull the trigger back to let the paint out. While holding the airbrush at a couple of inches from the object you want to pain, push the trigger on the top of the tool to apply the paint.Once you get some experience, you could experiment with higher pressure (20 psi) to get different results (mainly, lines texture). ![]() You should regulate the pressure to 10 psi to start. Keep the tip of the airbrush up, to avoid spilling the paint. ![]()
0 Comments
Leave a Reply. |